Tweet
I just bought a ‘68 model 39, 3.9hp. the lower unit is taking on water, and after researching I found out that its common for the carbon steel drive shaft to pit around the water pump housing. Mine is pitted. It was suggested to use speedi sleeves to press fit over the area where the seal sits. Anyone have any experience doing this?
-
-
Nude Teen Girls
b33tk995l, Free **** t732cq61p,
**** t608nx260r,
Nude Girls u338te370r,
**** Tube, o177lo928z. -
Nude Teen Girls
g675ea948s, Free **** z691mz332c **** h492ce536m,
Nude Girls i151yz619k **** Tube, n761vc770w, *** *** i812mu998o.Comment
Comment