hello all , i have this motor that was givin to me , been sitting 2 yrs , i tried to crank it , starter solonoid is bad , jumped straight to starter it turns over , has fire but wont start . where do i go from there ? noticed oil coming out of the prop that seal is bad,i know to change water pump . i want to here it at least try to fire before i spend a bunch of money on it / thanks for the help in advance Tim
							
						
					Announcement
				
					Collapse
				
			
		
	
		
			
				No announcement yet.
				
			
				
	
1979 1150 140 hp
				
					Collapse
				
			
		
	X
- 
	
	
		
		
		
		
		
		
		
	
	
 Start with a compression test to see if all cylinders are even, if ok then probably will need to remove and clean carbs and fuel system.Regards
 Boats.net
 Mercury Outboard Parts
 MerCruiser Parts
 Force Outboard Parts
 Mariner Outboard Parts
 
- 
	
	
		
		
		
		
		
		
		
	
	
 On any engine that has been setting, a carb clean and rebuild is mandatory in my book. If fuel was left in carbs the fuel will evaporate and leave the oil residue behind forming a hard gum/varnish. Here is what I would do before investing any monies in motor.
 (1) Check compression on all 6 cylinders, it should be 100psi or higher. All cylinders should be within 10 psi of each other, if OK proceed to step 2
 (2) Check all 6 cylinders for proper spark, that ignition system should be able to a 3/8 air gap and be bright blue,if not check ignition system
 (3) Check lower unit for water and excess metal particles in oil
 (4) Remove carbs and clean/rebuild each
 (5) Replace fuel pump diaphram and any degraded or stiff fuel lines
 (6) Replace impeller
 Comment


 1979 1150 140 hp
									
									
									1979 1150 140 hp
								
Comment